Users Manual Part 1

B. The FMA Installation General
Before installing any components or cabling, read all notes on drawings and read all installation
procedures.
C. Advisories
The JetWave™ MCS-8562 Terminal FMA and the BUC-HPA subsystems include components
that radiate RF and microwave emissions in the band between 29.0 and 31.0 GHz.
All service technicians and operators must be informed of the potential hazards of RF and microwave
radiation. When installing and servicing equipment, exercise the safety precautions that follow.
W
ARNING: THIS EQUIPMENT RADIATES HIGH FREQUENCY RADIATION AND POSES
A RADIATION HAZARD. CONSIDERING THE WORST CASE CONDITION OF
100 PERCENT REFLECTION FOR THE FUSELAGE MOUNT ANTENNA,
HONEYWELL DEEMS IT NECESSARY TO ASSURE OEM FUSELAGE
ATTENUATION EXCEEDS 21.03 DB FOR FUSELAGE MOUNTED ANTENNAS
SYSTEM INSTALLATION. THIS IS THE MINIMUM ATTENUATION REQUIRED
FROM THE AIRCRAFT FUSELAGE TO ATTENUATE THE KA-BAND
RADIATION TO MEET A SAFE HUMAN EXPOSURE OF 1 MW/CM2 INSIDE
THE AIRCRAFT.
SERVICE TECHNICIANS AND OPERATORS MUST EXERCISE CARE TO
KEEP CLEAR OF THE ANTENNA’S BEAM WHILE PERFORMING
OPERATIONAL TESTS OR INSTALLATION VERIFICATION PROCEDURES.
DO NOT APPROACH WITHIN 66.6 FEET (20.3 METERS) OF THE FUSELAGE
MOUNTED ANTENNA ASSEMBLY DURING RADIO FREQUENCY
TRANSMISSION.
W
ARNING:
DURING ANTENNA OPERATION (TRANSMISSION), MAKE SURE THAT
MINIMIZE THE EXPOSURE OF ALL PERSONNEL TO ANY REFLECTED,
SCATTERED, OR DIRECT BEAMS.
WARNING:
SERVICE TECHNICIANS MUST OBEY STANDARD SAFETY PRECAUTIONS,
SUCH AS WEARING SAFETY GLASSES, TO PREVENT PERSONAL INJURY
WHILE INSTALLING OR PERFORMING SERVICE ON THIS UNIT.
WARNING:
THE FUSELAGE MOUNT OAE ASSEMBLY IS ELECTROSTATIC-SENSITIVE.
STANDARD ELECTROSTATIC-SENSITIVE HANDLING PROCEDURES MUST
BE OBSERVED.
CAUTION:
D. Unpacking and Inspection
This section describes how to make sure that the equipment is in good condition after shipping.
To unpack and inspect the equipment do as follows:
(1) Unpack the equipment components from the shipping container.
(2) Make sure that all components of the fuselage mount OAE subsystem as indicated on the
parts list/bill of materials are included.
(3) Visually examine the units for any shipping damage.
NOTE: Refer to Paragraph 3.6. Inspection of Waveguide.
Page 3-17
23-15-84
EFFECTIVITY
ALL
11 Nov 2020
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
JetWave™ MCS-8562 Terminal