User's Manual Part 6

Page 7-96
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
7.3 System Fails Post-Installation Checks
(1) To make sure that the system is correctly installed, do as follows:
(a) Make sure that the APM has been correctly configured and loaded. Refer to ARINC
ARINC 615A Software Data Load Process and this section to access the GUI to check
that the correct APM version is installed.
(b
) Make sure that all the LRUs and connections have been correctly installed.
1 Do continuity checks on wiring, validate communication cabling for Tx, Rx signal
integrity via cable analyzers, test RF cables with specialized RF cable testers, and
do power on and ground checks with LRUs disconnected for the check.
(c) Make sure that all LRUs power up and report "OK" status.
1 System status can be viewed at the AES Home and Status Info Page Figure 6-3.
(d) Make sure that the cable calibration procedure has been done. Refer to Cable
Calibration on page 6-12.
(e) Make sure that the navigation data is correct and that
the antenna alignment has been
done.
(f) Check for system internal inter
connect faults. Refer to JetWave™ System Fault Codes
on page 7-8.
(g) Make sure the system is connected correctly to the
navigation busses, check the system
for No traffic faults on the A429 ports. If No traffic faults are received, do as follows:
1 Check wiring and or make sure that the APM is configured for how the system is
wired.
(h) Check the system for User port Ethernet No layer 1 faults. I
f faults are received, do as
follows:
1 Check the APM for correct configuration.
RF TX
Modman
to KRFU
(B0)
Unknown (00) 0x 0001 TX IF Check the interconnecting RF
connection between the Modman
and KRFU LRUs.
0x 0002 50 MHz Ref
RF TX
KRFU to
OAE (B1)
Unknown (00) 0x 0001 TX Ka Band Check the interconnecting RF
connection between the KRFU and
OAE LRUs.
RF RX
(B2)
Unknown (00) 0x 0001 RX cabling Check the interconnecting RF
connection between the effected
LRUs.
0x 0002 Global beam lock TBD
Table 7-6. L3 Codes (Continued)
L1 L2 L3 Code L3 Description Repair Action
Draft as of 31 May 2017