User's Manual Part 2

Page 4-39

3 Mar 2017

23-15-29

SYSTEM DESCRIPTION AND INSTALLATION MANUAL

JetWave™ System

With the LAIM, the radome will be installed on the Radome skirt fairing assembly. Refer to Figure

4-20.

Electrical bonding from the Jetwave™ radome lightning diverters into the airframe must be less

than 25 milliohms.

NOTE:

The segmented diverter strips on Jetwave™ radomes do not have electrical continuity

between the segments (buttons). Bonding measurements must be made at the diverter

termination points on the radome (at the radome attachment fastener).

Figure 4-20. Radome Assembly Mounted on Radome Skirt Fairing (LAIM)

A. FMA Human Exposure to RF EM Fields

WARNING: THE JETWAVE™ SYSTEM IS A SOURCE OF NON-IONIZING RADIATION.

(1) The Minimum Safe Distance:

• FMA = 66.6 feet (20.3 m).

NOTE: The minimum safe distance for occupational/controlled exposure is determined

based on the computational method specified in FCC Office of Engineering and

Technology; Bulletin Number 65, Edition 97-01: Evaluating compliance with FCC

Guidelines

for human exposure to Radio Frequency Electromagnetic fields.

(2) The areas which the risk exists are based upon the location of the antenna. This means

pers

onnel operating on the apron, transient personnel, and the general population in the

controlled exposure category will not be exposed to levels in excess of the limits.

Maintenance personnel working close to the tail must be protected by disabling the

transmitter before they approach that area of the aircraft.

Draft as of 31 May 2017