User's Manual Part 2

Page 4-36
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
KA BAND RADIATION TO MEET A SAFE HUMAN EXPOSURE OF 1 MW/CM
2
INSIDE
THE AIRCRAFT.
WARNING: SERVICE TECHNICIANS AND OPERATORS MUST EXERCISE CARE TO KEEP
CLEAR OF THE A
NTENNA’S BEAM WHILE PERFORMING OPERATIONAL TESTS OR
INSTALLATION VERIFICATION PROCEDURES. DO NOT APPROACH WITHIN 30.3
FEET (9.24 METERS) OF THE TAIL MOUNT ANTENNA ASSEMBLY DURING RADIO
FREQUENCY TRANSMISSION
WARNING: DURING ANTENNA OPERATION (TRANSMISSION), ENSURE MINIMUM EXPOSURE
OF ALL PERSONN
EL TO ANY
REFLECTED, SCATTERED, OR DIRECT BEAMS.
WARNING: SERVICE TECHNICIANS MUST OBEY STANDARD SAFETY PRECAUTIONS, SUCH
AS WEARING SAFETY
GLASSES, TO PREVENT PERSONAL INJURY WHILE
INSTALLING OR PERFORMING SERVICE ON THIS UNIT.
D. TMA Unpacking and Inspection
This section describes how to make
sur
e
that the equipment is in good condition after shipping. To
unpack and inspect the equipment, do as follows:
(1) Unpack the equipment components from the shipping
container.
(2) Make sure that all the components of the tail mount OAE sub
system as indicated on the parts
list/bill of materials are included.
(3) Visually inspect the units for any shipping damage.
NOTE: Refer to Section 4.10 Inspection of Waveguide.
E. TMA Installation Kit Details
Other than the common components specified in Fig
ur
e 4-15, the installation kit for waveguide and
coax assemblies, wiring assemblies, brackets, clamps and mounting assembly will be airframe
specific. Refer to airframe specific wiring diagram for details.
Table 4-9. TMA RF Interconnect Common Installation Components
PN Description
SCD-90402677 WR42 to 2.92 mm coax adapter
MS29513-013 O-ring
MS29513-016 O-ring
90403559 Screw, waveguide and adapter mating flange attachment
MS51957-27 Screw, waveguide flange to TMA
NAS620C6 Washer, waveguide flange to TMA
Draft as of 31 May 2017