User's Manual Part 1
Table Of Contents
- TRANSMITTAL INFORMATION
- SECTION 1 INTRODUCTION
- SECTION 2 DESCRIPTION
- SECTION 3 SYSTEM PRE-CONFIGURATION
- SECTION 4 INSTALLATION
Page 4-22
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
• Connecting Bulkhead Interface, KRFU power and control interfaces.
• Position and installation of radome.
(1) Installation of the FMA Assembly
(a) Align the FMA assembly above adapter plate with an aircr
aft service hoist. Attach hoist
to the FMA lifting fixture at two locations on each side of fixture. Refer to Figure 4-9.
Figure 4-9. FMA Assembly
(b) Put the FMA onto the FMA mounting holes with alignment pins and make sure that the
wavegu
ide flange is pointed to the rear of the AIM or LAIM. Make sure that the pigtails
do not interfere to avoid damage.
(c) Remove the FMA lifting fixture. Refer to Figure 4-10.
Draft as of 31 May 2017