User's Manual Part 1

Page 4-18
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
than 1° off heading, pitch or roll with respect to principle axis of aircraft. Depending on the airframe,
as part of the OAE FMA, the LRUs and assemblies that follow will be installed outside aircraft:
•FMA LRU
• KRFU LRU (if installed outside aircraft)
• Radome assembly
• ARINC 791 based AIM or the LAIM
• Radome skirt fairing.
• ARINC 791 OAE installation kit (optional, for
ARINC 791 installs
only)
The exact install location of the ARINC 791 based AIM or LAIM and KRFU is airframe specific.
The KRFU can be installed on the inside or outside the fuselage of the aircraft. Honeywell
recommends to install the KRFU on the ARINC 791 based AIM or LAIM outside the fuselage of the
aircraft.
The radome, skirt fairing, and FMA/KRFU to aircraft interface brackets are airframe specific and
said details are not covered by this manual.
NOTE:
The ARINC 791 AIM is intended to be a common design solution across multiple aircraft
platforms. The only variable is the skirt and seal that change with the aircraft specific
fuselage contour.
or
The non ARINC 791 design has a common LAIM plate that is intended to be used across
all platforms. The variables in this design solution are the ring fairing that the radome
attaches to and the LAIM to fuselage interface brackets. The ring fairing is a design and
shape specific to the fuselage contour at the aircrafts installation location, as are the LAIM
to fuselage interface brackets.
Refer to the FMA outline and installation drawing in Figure 4-31, the KRFU outline and
installation drawings in Figure 4-27, Figure 4-28, and Figure 4-29, and the radome outline
and installation drawing in Figure 4-32. Depending on the aircraft configuration, refer to the
interconnect diagrams in Figure 4-35 for the KRFU installed inside the fuselage, and Figure
4-36 or Figure 4-37 for external KRFU.
Refer to Table 4-5 for special tools, fixtures, and equipment for the FMA installation.
B. The FMA Installation General
Before installing any components or cabling,
read all notes on drawings and read all installation
procedures.
Table 4-5. Special Tools for FMA Installation
Number Description Source
NA Hoist system Commercially available
NA Torque wrench Commercially available
066101 5/16” crowsfoot
spanner/wrench
Mountz (CAGE: 0HL78)
Draft as of 31 May 2017