User's Manual Part 1

Page 1-4
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
B. Other Publications
(1) These publications are standard references. Check for th
e latest version of the publication.
• The United States GPO Style Manual (
available at
http://www.gpo.gov/fdsys/pkg/GPO-STYLEMANUAL-2008/content-detail.html)
• IEEE Std 260.1, Standard Letter Symbols for Units of Measurement (available from
the
American National Standards Institute at http://www.ansi.org)
• ASME Y14.38, Abbreviations for Use on Drawings and Related Documents (available
from the Ame
rican National Standards Institute at http://www.ansi.org)
• ASME Y14.5, Dimensioning and Tolerancing (available from the American National
Standards Institute at http:/
/www.ansi.org)
• ANSI/IEEE Std 91, Graphic Symbols for Logic Functions (available from the American
Na
tional Standards Institute at http://www.ansi.org)
• CAGE codes and manufacturers’ addresses are availabl
e at https://cage.dla.mil
• IEEE 315/ANSI Y32.2, Graphic Symbols for Electrical and Electronics Diagrams
(availa
ble from the American National Standards InstituteInstitute at http://www.ansi.org)
• ARINC 791P1-2 Mark I Aviation Ku-Band and Ka-Band Satellite Communication System,
Part 1, Phy
sical Installation and Aircraft Interfaces.
1.7 Precautions
When working with avionics and satellite communications equipment, be aware of the following warnings
and cautions.
WARNING: TO PREVENT RADIO FREQUENCY OVEREXPOSURE, THE AREAS WHICH THE RISK
EXIS
TS IS BASED UPON THE LOCATION OF THE ANTENNA AND THE INSTALLED
HARDWARE END STOPS. TECHNICIANS WORKING IN CLOSE PROXIMITY OF THE
ANTENNA MUST BE PROTECTED BY DISABLING THE TRANSMITTER BEFORE
THEY APPROACH THAT AREA OF THE AIRCRAFT.
WARNING: SERVICE TECHNICIANS MUST OBEY STANDARD SAFETY PRECAUTIONS, SUCH
AS
WEARING SAFETY
GLASSES, TO PREVENT PERSONAL INJURY WHILE
INSTALLING OR PERFORMING SERVICE ON THIS SYSTEM.
CAUTION: TURN OFF POWER BEFORE DISCONNECTING ANY TERMINAL FROM WIRING.
DISCONNECTING THE TERMINAL WITHOUT TURNING POWER OFF MAY CAUSE
VOLTAGE TRANSIENTS THAT CAN DAMAGE THE TERMINAL.
Draft as of 31 May 2017