User's Manual Part 1

Page TI-8
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
6-13
Paragraph 6.5A, revised to add “or replacement” condition.
All
6-13
Paragraph 6.5A, Step (2), revised the physical installation
procedure.
All
6-14
Paragraph 6.6A., Step (3) revised the requirement for antenna
alignment.
All
6-14
Paragraph 6.6A, Step (5), replaced “open the link index.html”
with “enter 172.29.55.1 in the address bar”.
Step 6.6C(1), revised to add information for Geo stationary
satellite.
All
6-15
Steps 6.5C, Step (1), updated Figure 6-13 to latest.
All
6-15
Paragraph 6.6B, Step (2) and Step (3), revised to change
“headings” to “true headings”.
Added note to Paragraph 6.6B, Step (3) referring to the values
displayed.
All
6-16
Step 6.6B, Step (4), revised to change “headings” to “true
headings”.
All
6-17
Step 6.6B, Step (4), updated Figure 6-14 to latest.
All
6-17 and 6-18
Step 6.6A, Step (2), revised step (2) and added "If AES
Configuration System KANDU Ground Speed.
All
6-18
Step 6.7A(5), revised control of the transmission of the
terminal.
All
6-19
Paragraph 6.7A, added a note to give information that the 360
degree connectivity access can be limited for the Jetwave
system.
All
6-19
Paragraph 6.7A, Figure 6-15 was revised to include the latest
data.
All
7-2
Paragraph 7.2A, Step (1), added note for the health status
page.
All
7-3
Paragraph 7.2A. Step (1), updated Figure 7.3 to latest.
All
7-6
Paragraph 7.2B, Step (5) updated Figure 7.5 to latest.
All
7-7 Paragraph 7.2D, revised “By closure of the Modman reset pin
(MP10C) to ground” as “By grounding the Modman Reset Pin
(MP10C)”
All
Table of Highlights (Continued)
Page Description of Change Effectivity
Draft as of 31 May 2017