User's Manual Part 1

Page TI-7
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
6-2
Paragraph 6.1, revised “maximum spot beam capacity” to
“defined Maximum Information Rate” and “or Minimum” as “for
95% of the time”.
Revised to state that the updates do not adversely affect
system safety, operational capabilities and does not impact
flight crew workload.
Revised to remove "On the next power up"
All
6-3
Paragraph 6.1B, Step (2), replaced “Flight Load result” with
“test report”.
Paragraph 6.2, revised to add additional information on
certifications for antenna installations.
All
6-3
Paragraph 6.3B, revised the title as “System Health and
Configuration”.
All
6-4 Figure 6-1, revised the title to delete “AES User Level”. All
6-5 Paragraph 6.3B, added step “The laptop's Ethernet port will
need to be configured with a static IP address of 172.29.55.x,
where x is 10 or above“.
Replaced “open the link index.html” with “enter 172.29.55.1 in
the address bar”.
6-9 Paragraph 6.3B, added a note to follow the appropriate
Jetwave Service Bulletin to validate the software currently
installed.
All
6-10 Paragraph 6.3C, revised the title from “Modman Reset Input” to
“Discrete Input Testing”.
Updated Step 6.3C(1) and added Step (2).
Replaced Figure 6-8 with the latest version.
Added Note that follows Step 6.3D.
All
6-11 Paragraph 6.3E, updated the first note that follows Step E. All
6-12 Paragraph 6.4, added a new step for cable calibration. All
6-12 and 6-13 Paragraph 6.4, “AES Menu Access System” is replaced by
“GUI”.
Paragraph 6.4, added additional information for full
Optimization of Jetwave system.
All
Table of Highlights (Continued)
Page Description of Change Effectivity
Draft as of 31 May 2017