User Manual Part 3

Page 3-39

16 Sep 2015

23-15-29

SYSTEM DESCRIPTION AND INSTALLATION MANUAL

JetWave™ System

D. System Dataload Failure

(1) Make sure that the system is configured for ground operation.

(2) Make sure that the local data load enable switch is closed.

(3) Make sure that the 615A data loader is connected to the correct port:

NOTE:

AV1 by default, but this may have been modified by the configuration loaded on the

APM.

(4) Make sure you are trying to load a valid set of files into the correct LRU.

11. Network Monitoring

The JetWave™ system supplies network performance data to SNMP applications. The available MIB

objects and traps can be found in APPENDIX B on page B-1.

12. System Reset

The JetWave™ system can be reset with any of the methods that follow:

• Through the Web GUI

• Through the SNMP

• By closure of the Modman reset pin (MP10C) to ground.

NOTE:

The maintenance technician can attempt to cycle power to the Modman in case the system fails

to respond to the reset. If the problem persists, the respective AES sub assembly needs to be

replaced. Honeywell Field Support Engineers can be contacted for further support.

A. Electrical and Mechanical Inspection and Check

Periodic inspections of the mechanical and electrical interfaces of the JetWave™ AES OAE

assembly and LRUs to the aircraft should be completed as defined by the governing airworthiness

body (such as Transport Canada, the FAA, or the JAA) Instructions for Continued Airworthiness for

the installation.

For the general guidelines, refer to Visual Inspection and Check and Scheduled Maintenance and

Inspections sections.

B. Instructions for Continued Airworthiness

This section supplies the special instructions and maintenance requirements for continued

airworthiness of the JetWave™ AES subsystems.

(1) JetWave™ AES OAE assembly and LRUs are considered on-condition units. No additional

or routine maintenance is required for the on-condition JetWave™ AES OAE assembly and

LRUs.

(2) If a JetWave™ AES OAE assembly or an LRU is inoperative, do as follows: