User Manual Part 3

Page 3-25
16 Sep 2015
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Make sure that the network connectivity in accordance with the aircraft configuration plan.
With the use of another laptop, make sure that the network connectivity on each active port once
the data link available output is available.
Begin a two way (Rx and Tx) video conference call with a tool such as Microsoft Lync or Skype.
Make sure that the availability of the uninterrupted data connectivity. Monitor the Kilobytes sent and
received fields on the home page.
While the JetWave™ system is up and connectivity to internet is established, move the aircraft
around in a circular 360 degree pattern (no faster than 3° per second).
Verify that the connectivity remains available through the 360 degrees turn by monitoring the
datalink status discrete.
Connect to each of the configured Ethernet port to make sure there is data connectivity.
Figure 3-16. Network Statuses
K. EMC Interference to Other Systems
(1) Power up the system and let it acquire to the network.
(2) Begin a two way (Rx and Tx) video conference call with a tool such as Microsoft Lync or
Skype.
(3) Test the functioning of other communication systems with antennas installed adjacent to the
FMA or TMA and observe for any mutual interference.
(4) Monitor the link signal quality C/N and E
b
/N
o
parameters. These parameters are found under
Aircrarft Statuses as part of the AES Summary and Link Status page. Refer to Figure 3-13.