User Manual Part 3

Page 3-16
16 Sep 2015
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
On completion of AES system installation activities, the installer can view and make sure that the
JetWave™ LRUs status, AES configuration settings, discrete input and output status, and antenna
alignment status through the GUI as described in this section.
Once the Modman is powered up, the JetWave™
GUI page can be accessed. The JetWave™
system
GUI service is supported on AV1 10/100 Base T Ethernet interface. The Modman static IP
address assigned is 172.29.55.1 and the port no for the AES GUI service is 80.
Connect a laptop to the AV1 port of Modman through aircraft Ethernet interface. It is recommended
to use a laptop computer with the following minimum requirements:
• Intel i5 CPU
• 8 GB of RAM
• At least 500 MB of available hard drive space
• An available 10/100/1000 Ethernet interface
• Windows 7 operating system, 64-bit.
On any of the Internet browser (Internet Explorer 8 compatible), open the link "index.html". Login
page will be presented as the root page, allowing entry of the user name and password. Figure 3-6
shows the login page.
Figure 3-6. AES GUI Login Page
(l)
The GUI is configured to have the login accounts that follow:
• User interface with Username: "User" and Password: empty (no) password
• Maintenance interface with Username: "Maintenance" and Password: "Earthbound".
On successful login, the AES Home page screen is shown. Refer to Figure 3-7.
The information supplied on the AES Home page is as follows:
• Network status