User Manual Part 3

Page 3-7
16 Sep 2015
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
• Weight on Wheels discrete input availability and its polarity
• User Ethernet Ports which are to be configured and the type of services to be enabled (such as
Dataload, SNMP and GUI).
• Particulars of VAR/DPs providing the IP services
• Aircraft blockage data.
Refer to APPENDIX E on page D-1 for more details.
5. ARINC 615A Software Dataload Process
A. Introduction
The JetWave™ LRUs are preloaded with a full software load and there is no need to perform field
dataload under normal conditions during installation.
On completion of physical installation and interconnection of JetWave™ LRUs in the aircraft, it is
to be verified that the appropriate version of the JetWave™ LRU operational data and APM
configuration file is data loaded onto the JetWave™ LRUs.
The JetWave™ LRU operational data and APM configuration file are supplied as a media file. The
software data load can be carried out when the media files are issued separately along with Service
Bulletins for any in-service system updates.
Only Honeywell approved software is loadable onto JetWave™ LRUs.
This section of the document supplies information on how to accomplish ARINC 615A data loading
of JetWave™ system in the field.
The data loading of JetWave™ system is done while the aircraft is on ground. During the data load,
there will not be any RF transmission.
B. System Requirements
For data load, the data loader is to be interfaced with Modman through the ARINC 600 Modman
AV1 Ethernet port. The AES JetWave™ Modman is designed to enter into data load mode when
the discrete signal interface for Data load Enable is asserted (grounded) by ARINC 615A compliant
data loading utility. The discrete input electrical specification is in accordance with the specification
in ARINC 763 Section 2.9.6.
It is recommended that the Modman AV1 Maintenance port and Modman Data Load Enable
discrete interface be wired for JetWave™ AES data load and AES log extraction.
An ARINC 615A compliant data loading utility is recommended to be used for JetWave™ AES data
loading. The data loading software-based utility may be hosted on a PC architecture device such
as an Electronic Flight Bag (EFB) or other portable computing device, an on-board portable device,
or an avionics device. Since the Aircraft loading procedures can vary due to different type of
uploading means, it is recommended to refer to the appropriate Aircraft Maintenance Manual before
attempting data loading of JetWave™ AES system.
C. Procedure