User Manual Part 3

Page 3-61
16 Sep 2015
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
TMA (03) LNA (03) 0x 0001 LNA current Hardware faults and events:
- Replace the TMA.
NOTE:
Before removing the Tail Mount
Radome, Honeywell
recommends manually steering
the TMA through GUI to a safe
antenna orientation position.
The TMA parking position is
included in the AES System
Configuration File, which can be
accessed through the GUI web
interface and by navigating to
Configuration File page.
Consult aircraft specific SDIM
for detailed instructions.
Motor and sensors
(04)
0x 0001 AZ sensor detection
0x 0002 EL INIT sensor
detection
0x 0003 EL LIMIT sensor
detection
Position control
unit (05)
0x 0001 DSP fault Hardware faults and events:
- Replace the TMA.
NOTE:
Before removing the Tail Mount
Radome, Honeywell
recommends manually steering
the TMA through GUI to a safe
antenna orientation position.
The TMA parking position is
included in the AES System
Configuration File, which can be
accessed through the GUI web
interface and by navigating to
Configuration File page.
Consult aircraft specific SDIM
for detailed instructions.
0x 0002 AZ motor current draw
0x 0003 El motor current draw
0x 0004 Initialization incomplete
PSU (06) 0x 0003 OMAP PWR 3.3V:
Out-of Spec
0x 0004 OMAP PWR 5V: Out-of
Spec
0x 0005 MOT PWR 12V: Out-of
Spec
0x 0006 LNA PWR 12V: Out-of
Spec
Operational
information (FA)
0x 0000 Mode transition Info events - Recording what happened
in the LRU
0x 0001 Parameter
0x 0002 Event
0x 000A Standard electronic
information
0x 000B Honeywell electronic
information
0x 000C Subassembly
information
IP Security (FB) 0x 0000 IP Security event Use well defined port and IP Address
Reset (FC) 0x 0000 Power cycle Info events - Recording what happened
in the LRU
0x 0001 Watchdog
0x 0002 Software command
0x 0003 Reset pin
Table 3-20. L3 Codes (Cont)
L1 L2 L3 Code L3 Description Repair Action