User Manual Part 3

Page 3-53
16 Sep 2015
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
E. L3 Codes
(1) The L3 code is four hexadecimal digits, used to uniquely identify the fault or event against an
L1, L2 code pair.
(2) Each LRU defines their own L3 codes. These are given in the fault table, refer to Table 3-20.
Table 3-19. L2 Codes – User Interface
L1 L2 Code L2 Description
AISD Network: Ethernet AG1 (80)
AISD Network: Ethernet AV1 (81)
AISD Network: Ethernet AV2 (82)
AISD Network: Ethernet AV3 (83)
PIESD Network: Ethernet EG1 (88)
PIESD Network: Ethernet EN5 (89)
PIESD Network: Ethernet EN6 (8A)
PIESD Network: Ethernet EN7 (8B)
PIESD Network: Ethernet EN8 (8C)
PODD Network: Ethernet PG1 (90)
PODD Network: Ethernet PA1 (91)
PODD Network: Ethernet PA2 (92)
PODD Network: Ethernet PA3 (93)
PODD Network: Ethernet PA4 (94)
0x 01 Modman input
Table 3-20. L3 Codes
L1 L2 L3 Code L3 Description Repair Action
System (00) Unknown (00) 0x 0001 OAE not pointed
correctly
Try a manual point and see if it works.
Mode (01) 0x 0000 Critical fault mode entry - Info events - Recording what happened
in the LRU.
- If it is a warning, It is info only.
0x 0001 Dataload mode entry
0x 0002 Commanded mode
entry
0x 0003 Normal mode entry
AES menu access
level (02)
0x 0000 Maintenance
0x 0001 Factory
0x 0002 Engineering
0x 0021 Log clearance AES
operational historical
log
0x 0022 Log clearance AES fault
historical log