User Manual Part 1

Page 2-33

16 Sep 2015

23-15-29

SYSTEM DESCRIPTION AND INSTALLATION MANUAL

JetWave™ System

The IF TX and IF RX signals to KRFU are supplied from the Modman. These are routed

through bulkhead interface. Refer to the appropriate FMA interconnection diagram Figure

2-34, Figure 2-35, or Figure 2-36 for details.

(a) Remove the protective covers from the FMA P2 and KANDU J2 receptacles. Visually

examine the connectors and make sure that the pins are straight and undamaged.

1 Clean the connectors with the contact cleaner and connect the cable assembly for

fuselage mount from the KANDU J2 receptacle to the FMA P1, P2, and P3

receptacles.

2 Make sure that the over braid of the cable assembly is terminated to connectors at

both the FMA and KANDU ends.

(b) Remove the protective covers from the KRFU J2 and KANDU J3 receptacles. Visually

amine the connectors and make sure that the pins are straight and undamaged.

1 Clean the connectors with the contact cleaner and connect the cable assembly for

fuselage mount from the KANDU J3 receptacle to the KRFU J2 receptacle.

2 Make sure that the over braid of the cable assembly is terminated to connectors at

both the KRFU and KANDU ends.

s. Visually

examine the connector ends and ensure there is no debris in central connector cavity.

1 Clean the connectors with the contact cleaner before connecting.

2 Make sure that the TX-IF coax cable is banded blue and RX-IF coax cable is

banded green at connector ends.

3 Make sure that the over braid of the cable assembly is terminated to connectors at

both the KRFU and bulkhead interface feed through ends.

4 The over braid can be terminated to the connector shield/housing or directly to the

housing.

(d) Make sure that all the cable assembly routing are firmly held with wire clamps in

accordance with the airframe specific wiring di

agram and there are no obstruction to the

free movement of the FMA. Refer to Figure 2-18 for the A791 based AIM and Figure

2-18

for the LAIM.