User Manual Part 1

Page 2-23
16 Sep 2015
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
WARNING: THIS EQUIPMENT RADIATES HIGH FREQUENCY RADIATION AND POSES A
RADIATION HAZARD. CONSIDERING THE WORST CASE CONDITION OF 100
PERCENT REFLECTION FOR THE FUSELAGE MOUNT ANTENNA,
HONEYWELL DEEMS IT NECESSARY TO ASSURE OEM FUSELAGE
ATTENUATION EXCEEDS 21.03 dB FOR FUSELAGE MOUNTED ANTENNAS
SYSTEM INSTALLATION. THIS IS THE MINIMUM ATTENUATION REQUIRED
FROM THE AIRCRAFT FUSELAGE TO ATTENUATE THE KA-BAND RADIATION
TO MEET A SAFE HUMAN EXPOSURE OF 1 MW/CM
2
INSIDE THE AIRCRAFT.
WARNING: SERVICE TECHNICIANS AND OPERATORS MUST EXERCISE CARE TO KEEP
CLEAR OF THE ANTENNA’S BEAM WHILE PERFORMING OPERATIONAL
TESTS OR INSTALLATION VERIFICATION PROCEDURES. DO NOT
APPROACH WITHIN 66.6 FEET (20.3 METERS) OF THE FUSELAGE MOUNTED
ANTEN
NA ASSEMBLY DURIN
G RADIO FREQUENCY TRANSMISSION.
WARNING: DURING ANTENNA OPERATION (TRANSMISSION), MAKE SURE THAT
MINIMIZE THE EXPOSURE OF ALL PERSONNEL TO ANY REFLECTED,
SCATTERED, OR DIRECT BEAMS.
CAUTION: SERVICE TECHNICIANS MUST OBEY STANDARD SAFETY PRECAUTIONS,
SUCH AS WEARING SAFETY GLASSES, TO PREVENT PERSONAL INJURY
WHILE INSTALLING OR PERFORMING SERVICE ON THIS UNIT.
CAUTION: THE FUSELAGE MOUNT OAE ASSEMBLY IS ELECTROSTATIC-SENSITIVE.
STANDARD ELECTROSTATIC-SENSITIVE HANDLING PROCEDURES MUST BE
OBSERVED.
(4) Unpacking and Inspection
This section describes how to make sure that the equipment is in
good condition after
shipping. To unpack and inspect the equipment do as follows:
(a) Unpack the equipment components from the shipping container.
(b) Make sure that all components of the fuselage mount OAE subsystem as indicated on
the
parts list / bill of materials are included.
(c) Visually examine the units for any shipping damage.
(5) FMA Installation Kits
Other than the parts list specified in Table 2-7, the installation kit for the A791 ba
sed AIM or
the LAIM, waveguide and coax assemblies, wiring assemblies, brackets, clamps, and
mounting assembly will be airframe specific. Refer to airframe specific wiring diagram for
details. The radome skirt fairing will be airframe specific. The LAIM will be a custom solution
for a particular airframe.
Table 2-7. FMA installation Kits
PN Description
SCD-90402677 WR42 to 2.92 mm coax adapter