User Manual Part 1

Page INTRO-4

16 Sep 2015

23-15-29

SYSTEM DESCRIPTION AND INSTALLATION MANUAL

JetWave™ System

• ANSI/IEEE Std 91, Graphic Symbols for Logic Functions (available from the American

National Standards Institute at http://www.ansi.org)

• H4/H8 CAGE Codes (available from DLA Logistics Information Services at

http://www.logisticsinformationservice.dla.mil)

• IEEE 315/ANSI Y32.2, Graphic Symbols for Electrical and Electronics Diagrams

(available from the American National Standards InstituteInstitute at http://www.ansi.org)

• ARINC 791P1-2 Mark I Aviation Ku-Band and Ka-Band Satellite Communication System,

Part 1, Physical Installation and Aircraft Interfaces.

7. Precautions

When working with avionics and satellite communications equipment, be aware of the following warnings

and cautions.

CAUTION:

TO PREVENT RADIO FREQUENCY OVEREXPOSURE, THE AREAS WHICH THE RISK

EXISTS IS BASED UPON THE LOCATION OF THE ANTENNA AND THE INSTALLED

HARDWARE END STOPS. TECHNICIANS WORKING IN CLOSE PROXIMITY OF THE

ANTENNA MUST BE PROTECTED BY DISABLING THE TRANSMITTER BEFORE THEY

APPROACH THAT AREA OF THE AIRCRAFT.

CAUTION:

SERVICE TECHNICIANS MUST OBEY STANDARD SAFETY PRECAUTIONS, SUCH AS

WEARING SAFETY GLASSES, TO PREVENT PERSONAL INJURY WHILE INSTALLING

OR PERFORMING SERVICE ON THIS SYSTEM.

CAUTION:

TURN OFF POWER BEFORE DISCONNECTING ANY TERMINAL FROM WIRING.

DISCONNECTING THE TERMINAL WITHOUT TURNING POWER OFF MAY CAUSE

VOLTAGE TRANSIENTS THAT CAN DAMAGE THE TERMINAL.

CAUTION:

THIS EQUIPMENT INCLUDES ITEMS THAT ARE ELECTROSTATIC DISCHARGE

SENSITIVE DEVICES. ELECTROSTATIC DISCHARGE SENSITIVE DEVICES ARE

SUBJECT TO DAMAGE BY EXCESSIVE LEVELS OF VOLTAGE AND/OR CURRENT. THE

LOW-ENERGY SOURCE THAT MOST COMMONLY DESTROYS ESDS DEVICES IS THE

HUMAN BODY, WHICH, IN CONJUNCTION WITH NONCONDUCTIVE GARMENTS AND

FLOOR COVERINGS, GENERATES AND RETAINS STATIC ELECTRICITY. TO

ADEQUATELY PROTECT ESDS DEVICES, THE DEVICE AND EVERYTHING THAT

CONTACTS IT MUST BE BROUGHT TO GROUND POTENTIAL BY PROVIDING A

CONDUCTIVE SURFACE AND DISCHARGE PATHS. USE STANDARD INDUSTRY

PRECAUTIONS TO KEEP RISK OF DAMAGE TO A MINIMUM WHEN TOUCHING,

REMOVING, OR SERVICING THE EQUIPMENT.

8. Acronyms and Abbreviations

A. General

(1) The abbreviations are used in agreement with ASME Y14.38.

(2) Acronyms and non-standard abbreviations used in this publication are as follows: