System Description
Table Of Contents
- TITLE
- Honeywell Materials License Agreement
- RECORD OF REVISIONS
- SERVICE BULLETIN LIST
- LIST OF EFFECTIVE PAGES
- TABLE OF CONTENTS
- ABOUT THIS MANUAL
- INTRODUCTION
- EQUIPMENT DRAWINGS
- INSTALLATION
- SYSTEM SETUP
- TROUBLESHOOTING
- APPENDIX A: SPECIFICATIONS
- 1. HDU Inmarsat Terminal
- 2. Integrated Power and Low-noise Amplifier and Diplexer (IPLD)
- 3. External Satcom Configuration Module
- 4. Blade Antenna
- 5. AMT-3500 Intermediate Gain Antenna
- 6. AMT-1800 High Gain Antenna
- 7. AMT-3800 High Gain Antenna
- 8. AMT-700 High Gain Antenna
- 9. CNX-200Series 2 Network Accelerator
- 10. CCU-200
- 11. CNX-250
- 12. CNX-900
- APPENDIX B: GLOSSARY
Page 5-1
28 Feb 2018
23-15-45
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
Aspire-200
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM SETUP
1. Setting up Operational Parameters
After the Aspire-200 is installed in the aircraft, you must configure fundamental parameters in order to operate
the system:
• Cable losses
• LES IDs
• The APN
• Navigational input to the system.
A. Connecting to the Aspire-200 Maintenance Port
You can connect to the Aspire-200 through the maintenance port.
T
o connect to the maintenance port:
1. Connect your computer to
the front-panel maintenance port with the
maintenance cable, PN 1541-F-3150, provided in the shipping kit.
2. Start a HyperTerminal session on an active COM port with the following
parameters:
3. Type the password maint.
Th
e password does not appear on screen.
Menu 1 a
ppears when you connect.
B. Configuring Cable Loss
The signal loss in cables between the IPLD and the antenna affect the power
required to access Inmarsat services.
After you install the system, measure the
cable loss and configure the IPLD-to-antenna cable loss parameter.
Parameter Value
Bits per second 19200
Data bits 8
Parity None
Stop bits 1
Flow control None