System Description

Page 6-5
4 Dec 2015
23-15-45
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
Aspire-200
© Honeywell International Inc. Do not copy without express permission of Honeywell.
C. System Config Strapping Report
The ascii digital inputs report provides information about the configuration straps
on the HDU.
To view the report, in the list of available reports, press the number next to system
config strapping.
Figure 6-2 provides an example of the ascii digital inputs report.
LOOK ANGLE=33.1 Antenna elevation angle to the satellite, with respect to the
horizontal axis of the aircraft
CHAN Th
e channel card number
C/N0 RF input Carrier-to-Noise (C/No) level; typically 50.0 to 55.0 for
Swift 64, 55.0 to 60.0 for SBB
SIG dB RF input signal level—Typically -30 dB in Swift 64 and -50 dB
in SBB
TEMP HDU internal temperature
BEAM Satellite beam on which the card is registered
STAT System call status
BT Boot state
OC Registration Status
TX Transmit frequency
dBW EIRP dBw
WATT EIRP output
Table 6-1 VT100 Scenario Report Content (Continued)
Output Example Description
19308.354: NO SELFTEST NO TEMPERATURE FAULT NO CC OVERTEMP CC ENABLED
DATALOADER NOT CONNECTED PSU OK OCXO READY POWER GOOD
SYS-CONFIG='10 -- AMT-700 (HGA,SBB class 6, S64)'
19309.354: NO SELFTEST NO TEMPERATURE FAULT NO CC OVERTEMP CC ENABLED
DATALOADER NOT CONNECTED PSU OK OCXO READY POWER GOOD
SYS-CONFIG='10 -- AMT-700 (HGA,SBB class 6, S64)'
19310.355: NO SELFTEST NO TEMPERATURE FAULT NO CC OVERTEMP CC ENABLED
DATALOADER NOT CONNECTED PSU OK OCXO READY POWER GOOD
SYS-CONFIG='10 -- AMT-700 (HGA,SBB class 6, S64)'
19311.355: NO SELFTEST NO TEMPERATURE FAULT NO CC OVERTEMP CC ENABLED
DATALOADER NOT CONNECTED PSU OK OCXO READY POWER GOOD
SYS-CONFIG='10 -- AMT-700 (HGA,SBB class 6, S64)'