System Description
Table Of Contents
- TITLE
- Honeywell Materials License Agreement
- RECORD OF REVISIONS
- SERVICE BULLETIN LIST
- LIST OF EFFECTIVE PAGES
- TABLE OF CONTENTS
- ABOUT THIS MANUAL
- INTRODUCTION
- EQUIPMENT DRAWINGS
- INSTALLATION
- SYSTEM SETUP
- TROUBLESHOOTING
- APPENDIX A: SPECIFICATIONS
- 1. HDU Inmarsat Terminal
- 2. Integrated Power and Low-noise Amplifier and Diplexer (IPLD)
- 3. External Satcom Configuration Module
- 4. Blade Antenna
- 5. AMT-3500 Intermediate Gain Antenna
- 6. AMT-1800 High Gain Antenna
- 7. AMT-3800 High Gain Antenna
- 8. AMT-700 High Gain Antenna
- 9. CNX-200Series 2 Network Accelerator
- 10. CCU-200
- 11. CNX-250
- 12. CNX-900
- APPENDIX B: GLOSSARY
Page 5-8
28 Feb 2018
23-15-45
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
Aspire-200
© Honeywell International Inc. Do not copy without express permission of Honeywell.
5. To enter the ROLL parameter Navigate to menu 3 select option m then select
option 94. Enter the ROLL parameter value noting the correct sign, either + or
-. The following text will be displayed after selecting option 94. It will display the
current ROLL parameter value and provide the option to enter a new ROLL
parameter value. Values displayed below are examples only. Once a parameter
is entered and accepted the system will display EEPROM UPDATED.
6. To enter the PITCH parameter Navigate to menu 3 select option m then select
option 95. Enter the PITCH parameter value noting the correct sign, either + or
-. The following text will be displayed after selecting option 95. It will display the
current PITCH parameter value and provide the option to enter a new PITCH
parameter value. Values displayed below are examples only. Once a parameter
is entered and accepted the system will display EEPROM UPDATED.
7. To enter the ROTATION parameter Navigate to menu 3 select option m then
select option 96. Enter the ROTATION parameter value noting the correct sign,
either + or -. The following text will be displayed after selecting option 96. It will
display the current ROTATION parameter value and provide the option to enter
a new ROTATION parameter value. Values displayed below are examples only.
Once a parameter is entered and accepted the system will display EEPROM
UPDATED.
WHICH PARAMETER # <CTRL> N for next page ?94
ANTENNA MOUNTING ANGLE (ROLL) 0.0 DEG
[ROLL IS POSITIVE IF RIGHT SIDE IS UP LOOKING
FRONT-WARDS]
ROLL = ?-1.2
EEPROM UPDATED
WHICH PARAMETER # <CTRL> N for next page ?95
ANTENNA MOUNTING ANGLE (PITCH) 0.0 DEG
[PITCH IS POSITIVE IF NOSE OF ANTENNA IS UP]
PITCH = ? 2.4
EEPROM UPDATED
WHICH PARAMETER # <CTRL> N for next page ?96
ANTENNA MOUNTING ANGLE (ROTATION) 0.0 DEG
[ROTATION IS POSITIVE CCW LOOKING DOWN ON
ANTENNA]
ROTATION = ?-1.1
EEPROM UPDATED