User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-X and HSD-Xi High-speed Data Terminal
23-15-30 F-1
8 MAY 09
APPENDIX F: SETTING UP SBB
This appendix describes how to set up a single client on a packet-switched SBB connection.
1. Requirements
To configure and use a background standard IP connection, you must connect a computer to
the Ethernet port of the HSD-X and HSD-Xi terminal. If you are connecting a computer or
router to the Ethernet port of the HSD-Xi terminal, use a RJ-45 cross-over cable. If you are
connecting a hub or switch, use a RJ-45 straight-through cable.
2. Configuring a Standard IP Primary PDP Context
The connection that you configure in this section defines the primary PDP context. You can
configure any type of connection for the primary PDP context, but a standard IP connection,
as illustrated in this procedure, is the most common and useful. To create other connections,
see "Creating Connections for Other Services" on page F-7.
NOTE: This connection must be active before you can establish other connections with other
PDP contexts.
(a) To create a PPPoE connection
1. Click the Start button, point
to Settings, and then click Control Panel.
The Control Panel appears.
2. Double-click Net
work Connections.
The Network Connections window appears, as shown in Figure F-1.
Figure F-1 Network Connections Window