User's Manual
Table Of Contents
- Introduction
- System Description
- System Operation
- Installation
- Test and Fault Isolation
- Maintenance and Repair
- 1. Maintenance
- 2. Repair
- 3. Instructions for Continued Airworthiness
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: Installation Planning Checklist
- Appendix D: Installation Checklist
- Appendix E: Inmarsat Cause Codes
- Appendix F: Setting Up SBB
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-X and HSD-Xi High-speed Data Terminal
23-15-30 5-7
8 MAY 09
8. To load application software, type 24.
9. Press ENTER.
The system prompts you for a filename.
NOTE: The filename follows the format li_XX.bin.
10.Type the filename of the software.
11. Press ENTER.
The program prompts you to select a COM port.
12.Type the COM port connected to the HSD-Xi terminal, and then press ENTER.
13.To start the load, press ENTER.
A percentage (%) progress indicator appea
rs on the screen. A confirmation
message briefly appears on the screen indicating that the file has been
successfully loaded, and the DOS window closes. This completes the software
load.
When you finish loading all the s
oftware load, make sure the software loaded successfully
by following "Verifying Software Loads" on page 5-7
If a software load fails, restart the lo
ad from the beginning of the procedure. If, after two
attempts, the load still does not complete successfully, contact EMS SATCOM Product
Support for assistance.
(3) Verifying Software Loads
After loading all software as
specified in the applicable software service bulletin
released by EMS SATCOM verify that all software loaded successfully.
NOTE: The screens shown in this procedure are examples only. The software and
other versions may differ from your terminal.
To verify software loads:
1. Apply power to the HSD-Xi terminal.
2. On the computer, open a terminal emula
tion program, such as HyperTerminal,
and start the HSD-Xi terminal MPU.
3. Connect the computer to the maintenance port of the HSD-Xi terminal.
4. Type maint, an
d then press ENTER.
Menu 1 appears.
5. To scroll to Menu 2, press CTRL+N.
6. To display the versions of software loaded onto the HSD-Xi terminal, press V.
A list of firmware versions appears similar
to the example provided below (actual
versions will differ depending on the software installed on the terminal).
FIRMWARE VERSIONS:
KERNEL: V1.4 -- Wed Feb 21 08:58:08 2007
APPLICATION: V11.9 -- Wed Mar 28 10:07:24 2007
CHANNEL CARD #1: 4.9.8.0 -- 0.3.6.2 -- 2.1.0.0 -- 2.7.0.0
CHANNEL CARD #2: 1.17.0.1 -- -- -- 2.7.0.0
DATA I/O CARD: Version 1.39.0.0 built on Feb 2 2007 13: