User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page D–2
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
Installation/Electrical
Power Connections
+
28 V dc polarity
115 V ac polarity
Chassis grounding
Voltage Measurements
+
28 V dc level
115 V ac level
IRS Input IRS wiring
IRS format
Configuration Strap Pins SDI
System configuration
Data I/O
Forward Address
WOW (optional)
Ethernet Strapped to RJ45 distribution points
ISDN Strapped to RJ45 distribution points
MPDS Strapped to DB9S distribution
connectors
Remotes Manual Reset switch operation
Remotes Maintenance port (DB9S access)
Power and Fault LED indicators
RF Coax Rx i/p cable loss
Tx o/p cable loss
Antenna Connection Antenna manufacturer and type
Wired as per manufacturer
Multi-control loopbacks installed
Configuration Access codes
Channel cards
Stand-Alone mode
Valid beams
Forward ID
RF i/p attenuation
TEST
System Power-up Visual LED indications
Power-up computer display
TEST
On-air
System Log-on Reset messages observed
Log-on verified
Voice/Data Call Voice/data aircraft all placed
Section Parameter Item N/A R Value