User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page 1–5
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
B. Software Description
This section describes the software specifications and operational software components
of the HSD and HSD-X transceivers. It also describes the software requirements and
compatibility issues for each mode of operation.
(1) Software Specifications
The operating software of the HSD and HSD-X transceivers meets with
RTCA/DO-178B Level E requirements.
HSD-128 PN 1110-A-0150
HSD High-speed Data SATCOM Transceiver: High-speed data terminal
containing two channel cards, a control processor, a Data I/O Type 2 card, a high
power amplifier, and a 115 V ac, 400 hertz (Hz) power supply. Operates with an
Aero H/H+ (ARINC 741 compatible) antenna subsystem to provide circuit
(Swift64 Mobile ISDN), packet-switched HSD (Swift64 MPDS), and Mini-M
AMBE services over the Inmarsat satellite communications network. Supports
Ethernet connections.
HSD-128 PN 1110-A-0160
HSD High-speed Data SATCOM Transceiver: High-speed data terminal
containing two channel cards, a control processor, a Data I/O Type 2 card, a high
power amplifier, and a a +28 V dc power supply. Operates with an Aero H/H+
(ARINC 741 compatible) antenna subsystem to provide circuit (Swift64 Mobile
ISDN), packet-switched HSD (Swift64 MPDS), and Mini-M AMBE services over
the Inmarsat satellite communications network. Supports Ethernet connections.
HSD-64 PN 1110-A-0070
HSD High-speed Data SATCOM Transceiver: High-speed data terminal
containing one channel card, a control processor, a high power amplifier, and a
115 V ac, 400 hertz (Hz) power supply. Operates with an Aero H/H+ (ARINC 741
compatible) antenna subsystem to provide circuit (Swift64 Mobile ISDN),
packet-switched HSD (Swift64 MPDS), and
Mini-M AMBE services over the Inmarsat satellite communications network.
HSD-64 PN 1110-A-0080
HSD High-speed Data SATCOM Transceiver: High-speed data terminal
containing one channel card, a control processor, a high power amplifier, and a
+28 V dc power supply. Operates with an Aero H/H+ (ARINC 741 compatible)
antenna subsystem to provide circuit (Swift64 Mobile ISDN), packet-switched
HSD (Swift64 MPDS), and Mini-M AMBE services over the Inmarsat satellite
communications network.
HSD-X PN 1110-A-0401
The HSD-X High-speed Data SATCOM Transceiver Extension contains a single
channel card, a High Stability Reference, an Output Amplifier, a Data Processor
module, and a 115 V ac 400 hertz (Hz) power supply. It operates in conjunction
with an HSD-128 transceiver to provide Inmarsat Swift64 services and Mini-M
AMBE voice services. This transceiver supports Multi-Channel HSD
configurations by adding additional channels to HSD-128 systems.
Table 1–3. Equipment Covered
Model Description