User's Manual

Page 4–103
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
13. To save an alternate “reports” configuration, activate the required items and then
press
S (in the “reports” menu) to save to EEPROM.
14. Using Ctrl+N, go to menu 3, and then do one of the following:
• For units operating control processor software earlier than version 5.7, press
L to display EEPROM parameters. (The EEPROM list displays one terminal
screen of information at a time. Press
L to display subsequent screens.)
• For units operating control processor software later than version 5.7, press
O to display the ORT List. (The ORT list displays one terminal screen of
information at a time. Press
O to display the next screen.)
15. In menu 3, press S (list event log) and then press zero “0” and then press the
period key “
.” to list the complete event log.
16. In menu 3, press F (list call log), then press F again (complete log) and then press
the period key “
.” to the complete event log.” For extended information, press X.
17. Close the log file on the terminal program.
18. The log file is in text format (.txt file). Open the file and add notes to the beginning
of the file indicating:
• System serial number (from the label on the front of the unit)
• Aircraft and customer name
• Any notes about the problems encountered
• Contact name, telephone number, and e-mail address
• E-mail the log file to EMS Technologies technical support at:
[e-mail]