User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page 1–3
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
2. Equipment Covered
A. Hardware Description
Table 1–2 provides a comparison of the Hardware variants of HSD and HSD-X
transceivers. Table 1–3 lists and describes all models of HSD transceivers covered in this
manual.
Table 1–2. HSD Transceiver Variants
Model
Assembly
PN
Channel
Card(s)
Operational
Modes/
Configurations
Interconnection
Diagram
Voltage
(nominal)
Power
(nom/
max)
HSD-128 1110-A-0001 2 Stand-Alone 1110-B-0019 28 V dc 275/370 W
Multi-Channel
Configuration (with
Service Bulletin
1110-SB-0012
accomplished)
1110-B-0419
HSD-128 1110-A-0060 2 Stand-Alone 1110-B-0019 115 V ac/
400 Hz
275/385 W
Multi-Channel
Configuration (with
Service Bulletin
1110-SB-0012
accomplished)
1110-B-0419
HSD-128 1110-A-0001 2 Selective/Honeywell
Combined (with
Service Bulletin
1110-SB-0005
accomplished)
1110-B-0081 28 V dc 325/370 W
Collins Co-operative 1110-B-0156
HSD-128 1110-A-0060 2 Selective/Honeywell
Combined (with
Service Bulletin
1110-SB-0005
accomplished)
1110-B-0081 115 V ac/
400 Hz
325/385 W
Collins Co-operative 1110-B-0156
HSD-128 1110-A-0150 2 Stand-Alone 1110-B-0019 115 V ac/
400 Hz
325/385 W
Collins Co-operative 1110-B-0156
Selective/Honeywell
Combined
1110-B-0081
Multi-Channel
Configuration
1110-B-0419