User's Manual

Page 4–28
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
(g) Menu 14
Menu 14 items are used for debugging and clarifying call routing issues. Menu
14 is the same in all control processor software versions 4.5 and later.
Figure 4–23 shows the HSD maintenance utility program Menu 14 screen
display. Table 4–15 describes the items available in Menu 14.
Figure 4–23. Menu 14 Screen Display
Table 4–14. Menu 13 Item Descriptions
Menu Item Item Description
T: query Data IO elapsed
time
• Displays the time (in seconds) since the last Data I/O
reset
S: query Data IO services
• Displays active interfaces
F: Data IO fault logging
level
• Sets the level of minimum severity of events that are
reported to the Data I/O card
V: query Data IO version
• Displays the firmware version of the Data I/O card
C: query Data I/O config
pins
• Displays the Data I/O configuration pin summary
X: Data IO console mode
• Opens a virtual TTY session to the Data I/O
maintenance port on the HSD
MENU 14 FIRMWARE Vx.x
N num entries in call table L list call table
T get call table
<CTRL> N next menu <CTRL> O previous menu = select reports
Table 4–15. Menu 14 Item Descriptions
Menu Item Item Description
N: num entries in call
table
• Displays the call table number entries for
fixed-originated or mobile-originated calls for either
channel card 1 or channel card 2
T: get call table
• Displays the call table lists for fixed-originated or
mobile-originated calls for either channel card 1 or
channel card 2
L: list call table
• Lists the call table for fixed-originated or
mobile-originated calls for either channel card 1 or
channel card 2