User's Manual

Page 4–25
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
(d) Menu 4
In control-processor software version 7.0, the following changes were made to
Menu 4 selections (delta between version 4.5 and 7.0). No additional menu items
were added with the release of Version 7.5, Control Processor software.
• Removed Menu 4, item F, ‘force spot beam’ selection.
Figure 4–20 shows the HSD maintenance utility program Menu 4 screen display.
Table 4–12 describes the items available in Menu 4.
Figure 4–20. Menu 4 Screen Display
MENU 4 FIRMWARE V7.0
Q channel card forward ID's O set Ocean Region
S change spot beam J toggle ISDN connection
M report MUX stats
<CTRL> N next menu <CTRL> O previous menu = select reports
Table 4–12. Menu 4 Item Descriptions
Menu Item Item Description
Q: channel card
forward IDs
• Enables viewing of channel cards, # 1 and # 2 Forward IDs
O: set Ocean Region
• Allows for manual selection of satellite Ocean Regions:
AORW:
“0”
AORE:
“1”
POR:
“2”
IOR:
“3”
• To revert to programmed selection, type
–1 and press Enter
for AUTO selection
J: toggle ISDN
connection
• Used for testing and fault isolation purposes
• Connects ISDN 1 lines to Channel Card 2 (Does not work
in reverse—ISDN 2 to ISDN 1)
• Redirection only applies until the system is reset
S: change spot beam
• Enables manual selection of specific spot beams
independently assigned for each channel card
M: report MUX stats
• Not applicable
• Used for engineering debugging purposes only