User's Manual

Page 4–19
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
Note: Depending on the version of software installed and the Terminal Category,
the EEPROM Listing shown may differ from those shown and described
here.
Figure 4–18. Menu 3 – Item M: Miscellaneous Parameters (Version 4.5)
Figure 4–19. Menu 3 – Item M: Miscellaneous Parameters (Version 7.0)
<CTRL> N next menu <CTRL> O previous menu = select reports
MISCELLANEOUS PARAMETERS
1 HPA-ANTENNA CABLE LOSS 18 AOR E VALID BEAMS
2 FORWARD ID 19 POR VALID BEAMS
3 AORW LES ACCESS CODE 20 IOR VALID BEAMS
4 TERRESTRIAL NETWORK ID 21 AORE LES ACCESS CODE
10 NUMBER OF CHANNEL CARDS 22 POR LES ACCESS CODE
11 FRONT PANEL LEDS ENABLED 23 IOR LES ACCESS CODE
12 RX ATTENUATION (LAND-ON-WINGS) 24 RECEIVER CALIBRATION (AERO)
14 MAINTENANCE PORT INVERSE VIDEO 28 RX32 ACTIVE
15 MAINTENANCE PORT DEGREES SYMBOL 29 DEFAULT LATITUDE
16 TERMINAL CATEGORY 30 DEFAULT LONGITUDE
17 AOR W VALID BEAMS 31 OBEY OXCO STATUS
WHICH PARAMETER # ?
MISCELLANEOUS PARAMETERS
1 HPA-TO-ANTENNA TOTAL LOSS 11 FRONT PANEL LEDS ENABLED
2 FORWARD ID 14 MAINTENANCE PORT INVERSE VIDEO
3 GPS PROTECTION ALGORITHMS 15 MAINTENANCE PORT DEGREES SYMBOL
4 REGISTRATION REQ'D BEFORE CALLS 16 TERMINAL CATEGORY
10 NUMBER OF CHANNEL CARDS 17 VIPER ANTENNA GAIN
WHICH PARAMETER # <CTRL> N for next page ?
18 VIPER HPA/ANT LOSS 31 OBEY OXCO STATUS
24 RECEIVER CALIBRATION 42 HCM AERO/M4 PRIORITIZATION
28 RX32 ACTIVE 45 CATEGORY B LOWER FREQUENCY LIMIT
29 DEFAULT LATITUDE 46 CATEGORY B UPPER FREQUENCY LIMIT
30 DEFAULT LONGITUDE