User's Manual

Page 4–16
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
• Added parameter 45, ‘Category B Lower Frequency Limit’ and Parameter
46, “Category B Upper Frequency Limit” — these two parameters specify
the “CAT B” terminal frequency range. Calls, which involve transmitting
outside of this range, may interfere with the GPS navigational system if an
Aero H call occurs at the same time. Usually the GPS protection algorithm
tears down these calls.
Figure 4–16 shows the HSD maintenance utility program Menu 3 screen display
for version 7.0, control processor software. Table 4–9 describes the items
available in Menu 3.
Figure 4–16. Menu 3 Screen Display
MENU 3 FIRMWARE V7.0
L list EEPROM S list event log
M misc. EEPROM parameter F list call log
O list ORT P ocean region parameter
I set all LES id's
<CTRL> N next menu <CTRL> O previous menu = select reports
Table 4–9. Menu 3 Item Descriptions
Menu Item Item Description
L: list EEPROM
• Displays a list of all system EEPROM parameters and their
corresponding values (this function is READ only)
• Certain parameters are set using menu 3, item M selection.
Figure 4–17 shows an example of the EEPROM listing
S: list event log
• A list of system fault codes stored in non-volatile RAM
• When selected, several options are available:
0 = Most recent saved entry is displayed
S = Displays next most recent entry saved
• = Displays all remaining logged entries
1 = Special events (Does not include Ocean Region
Registration entries)
M: misc. EEPROM
parameter
• Enables entry or entry changes to some of the EEPROM
parameters listed in function ‘L’
Note: Parameters 5,6,7,8, 9, 13, 25, 26, 27, and 28 are
not accessible using Level 1 or Level 2 passwords
F: list call log
• Displays call log files for HSD or HSD-X. When selected,
two options are available:
Press “F” to display complete list of all log files
Press “X” to list extended EIRP trace data