User's Manual

Page 4–10
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
(b) Level 2 Menu Selections (Password: MAINT)
Figure 4–6 through Figure 4–12 show all menus and menu items available in
Level 2, menu options in control processor software, version 7.0. Menu items
added in version 7.0, control processor software are highlighted in bold. Where
applicable, any items that were deleted in version 7.0 are described and noted
below each menu. No additional menus or menu items were added with the
release of Version 7.5, Control Processor software.
Figure 4–6. Level 2: Menu 1
Figure 4–7. Level 2: Menu 2
Figure 4–8. Level 2: Menu 3
Note: In control processor software, version 7.0, menu 3, item N ‘serial number’
was removed.
MENU1 FIRMWARE V7.0
X override forward id L test LEDs
Y explain hpa error status S set hcm attenuator
R hcm RF threshold
<CTRL> N next menu <CTRL> O previous menu = select reports
MENU2 FIRMWARE V7.0
A set veh-relative azimuth E set veh-relative elevation
K desired az veh-rel velocity R resume automatic steering
T enter time of day N annotate log file
L re-enter logon password V get firmware versions
Z reset HSD-128 S set satellite longitude
<CTRL> N next menu <CTRL> O previous menu = select reports
MENU 3 FIRMWARE V7.0
L list EEPROM S list event log
M misc. EEPROM parameter F list call log
O list ORT P ocean region parameter
I set all LES id's
<CTRL> N next menu <CTRL> O previous menu = select reports