User's Manual

Page 3–49
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
1. ISDN Interface
Install an RJ-45 interface connector in the cabin area for user connections to
the ISDN interface.
"RJ-45 Connector Termination Details" on page 3-49
describes the RJ-45 connector and cable termination.
2. RS-232 Interface (MPDS)
Install a DB9S interface connector in the cabin area for connection to the
RS-232 interface. Refer to the HSD Interconnection Drawing for pinout
designation.
3. Ethernet Data Interface
HSD transceiver models, part numbers 1110-A-0150 and 1110-A-0160
support the Ethernet interface. All other models of HSD transceivers must
have service bulletin 1110-SB-0004 accomplished to support the Ethernet
interface.
Install an RJ-45 interface connector in the cabin area for user access to the
Ethernet interface.
"RJ-45 Connector Termination Details" on page 3-49
describes the RJ-45 connector and cable termination.
4. RJ-45 Connector Termination Details
Details relating to the RJ-45 cable terminations, required for both the ISDN
and/or 10BASE-T services, are shown in
Table 3–24 and Figure 3–15.
Use LAN cables that meet flammability and TIA/EIA568-A CAT-5
requirements. Cables #922404(4 conductor) and # 922408 (8 conductor), as
supplied by Electronics Cable Specialists, are acceptable. Equivalent
substitutions from other manufacturers may be used.
Table 3–24. RJ-45 Wiring Details – Cooperative Mode
Signal
SERVICE
EURO ISDN Ethernet 10BASE-T
Pin
Cable
Pin
Cable
ECS Other ECS Other
RX +
3 White White/Green 3 White White/Orange stripe
RX−
6 Blue Green 6 Green Orange/White stripe or
solid Orange
TX+
4 White Blue 1 White White/Green stripe
TX−
5 Orange White/Blue 2 Brown Green/White stripe or
solid Green