User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page 3–21
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
• A “restricted” channel is not handled by the Data I/O Controller, which
results in the channel not being accessible for SCPC via Ethernet or for
MPDS via RS232 or Ethernet.
• An SCPC channel is accessible for SCPC via Ethernet.
• An MPDS channel is accessible for MPDS via RS232 and Ethernet.
• An “unrestricted” channel is accessible for SCPC via Ethernet and MPDS
via RS232 and Ethernet.
Note: Use a ”Restricted” Data I/O Mode if only ISDN service is available.
Note: (‘0’ = FWD Address Common, ‘1’ No Connection)
Table 3–8. Data I/O Mode Pin Strapping – Stand-Alone
Pin Status
Data I/O Mode
MP5G MP5H MP5J MP5K
1111Invalid
11101 Restricted, 1 Unrestricted
11011 Restricted, 1 SCPC
11001 Restricted, 1 MPDS
10112 Restricted (ISDN only)
10102 SCPC
10011 SCPC, 1 Unrestricted
10002 MPDS
01111 MPDS, 1 Unrestricted
01101 SCPC, 1 MPDS
0 1 0 1 2 Unrestricted (recommended if no
specific user requirements)
0000Reserved