User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page 3–1
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
INSTALLATION
1. Introduction
This section provides general information and procedures required to install HSD transceivers
and HSD-X transceivers in Multi-Channel configurations on an aircraft. Mode-specific
installation instructions are provided in separate installation sections.
The organization of the installation information provided in this section is described below:
• General Installation
This section provides general installation information that applies to all modes and
configurations of HSD and HSD-X systems, including pre-installation instructions,
general cabling and connector requirements, information on installation kits, and
physical placement considerations.
• Section I: Stand-Alone Mode Installation
This section provides installation information specific to Stand-Alone Mode HSD
transceiver system configurations.
• Section II: Combined Mode (HCM)/Selective Mode Installation
This section provides installation information specific to Combined Mode and
Selective Mode HSD transceiver system configurations.
• Section III: Cooperative Mode Installation
This section provides installation information specific to Cooperative Mode HSD
transceiver system configurations.
• Section IV: Multi-Channel Configuration Installation
This section provides installation information specific to Multi-Channel HSD
transceiver system configurations that includes the installation of HSD-X transceiver
extension units.
If installation assistance is required, contact EMS SATCOM Product Support at the telephone
or fax numbers listed in the front matter of this manual.