User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
Page TC–1
18 September 2007
Table of Contents
INTRODUCTION
1. General .................................................................................................... TC-1
2. Abbreviations and Acronyms................................................................. TC-2
3. Advisories ................................................................................................ TC-4
4. Illustration of Equipment Covered......................................................... TC-5
SYSTEM DESCRIPTION
1. Purpose of Equipment .............................................................................. 1-1
2. Equipment Covered.................................................................................... 1-3
A. Hardware Description ......................................................................................... 1-3
B. Software Description .......................................................................................... 1-5
(1) Software Specifications ................................................................................. 1-5
(2) Operational Software Part Numbers.............................................................. 1-6
(3) Operational Mode Software Requirements.................................................... 1-6
(4) Software Version Description ........................................................................ 1-8
3. Equipment Description ............................................................................ 1-14
A. Applicable Documents...................................................................................... 1-14
B. Reference Documents...................................................................................... 1-14
C. Equipment Specifications ................................................................................. 1-14
D. Mechanical Description .................................................................................... 1-19
(1) HSD Transceiver ........................................................................................ 1-19
(2) HSD-X Transceiver...................................................................................... 1-19
E. Electrical Description........................................................................................ 1-20
(1) General ....................................................................................................... 1-20
(2) Pin and Connector Descriptions .................................................................. 1-21
F. System Interface Descriptions .......................................................................... 1-21
(1) HSD System Interfaces ............................................................................... 1-21
(2) HSD-X Multi-Channel System Interfaces .................................................... 1-24
G. User Interfaces ................................................................................................. 1-27