User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page 2–32
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
The ORT Tool allows users to customize certain user-defined parameters in the HSD
system such as:
• Satellite Data
• Service Provider Information
• LES Access Code selection
• Ethernet Configuration parameters (including IP Address information)
• Cable loss
The HSD ORT Tool has built-in help files that describe in detail the functionality of the tool.
To access the help file, open the ORT Tool and click on
Help.
(1) Creating an ORT using the HSD ORT Tool
This section describes how to create an HSD ORT file that can be loaded on to an
HSD/HSD-X transceiver for configuration purposes.
Note: The ORT Tool and ORT procedures described in this document may differ
from later versions of the ORT Tool. Click the ORT Tool
Help button for
up-to-date instructions.
Note: The HSD ORT Tool is a Windows-based program. Save the program file to
either your desktop or in the program files directory of your computer before
beginning.
To create an HSD ORT configuration file:
1. Double-click on the HSD ORT Tool Icon on your desktop or its filename in the
appropriate directory on your computer.
The HSD ORT Tool window appears.