User's Manual

SATCO
M
DIRECTORY
< CATEGORY0 1 CATEGORY0 3 >
< CATEGORY0 2 CATEGORY0 4 >
SAT
2
[ MANUAL D I AL ] PR I
3
RETURN>
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 2-26
3 JUN 10
2. To select a channel, on the SA
TCOM DIRECTORY page, press the key next
to SAT (the channel number).
3. To set the priority for your call
using Table 2-5, type the priority number on
the MCDU scratchpad and press the key next to PRI (
the priority value).
Table 2-5 Priority Codes
Call priority Description
1 Emergency—used for distress or urgent calls
2 Operational-High—used for Flight Safety communications
3 Operational-Lo—used for Regularity of Flight, Meteorological or
A
dministrative communications
4 Non-Operational—used for Non Safety of Flight or public phone
ca
ll (cabin) communications
4. To dial the call, type the phone number into the scratchpad and press the
key nex
t to MANUAL DIAL.
With Pre-Select Mode disabled, the MCDU
Main Menu page appears and
the HSD-440 Mark 2 Terminal initiates the call. With Pre-Select Mode
enabled, the MCDU Main Menu page appears.
• To start the call with Pre-Select mode enabled, in either Latched or PTT
m
ode, press the key next to MAKE CALL.
• To start the call in PTT mode with Pre-Select mode enabled, on the ACP,
assert the PLACE/END CALL 1 or PLACE/END CALL 2 switch.
or
assert the SAT 1 or SAT 2 switch and then press the PTT switch.
• To start the call In Latched mode with Pre-Select mode enabled, on the
ACP, assert the SAT 1 or SAT 2 switch.