User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 2-15
3 JUN 10
(a) Viewing the Log Status
The log status defines whether the HSD-440 Mark 2 Terminal is currently logged
on or logged off. The logon status can be:
• Logged-Off—The HSD-440 Mark 2 Terminal is logged off.
• Logged-Off Inop—The HSD-440 Mark 2 Terminal is configured to log on
manually but the terminal is in an inoperable state. Clear all problems
for the logon to continue.
• Logged-Off Rejected—The HSD-440 Mark 2 Terminal is logged on and
a second logon attempt is made. The second attempt fails and the status
is Logged-Off Rejected.
• Logging-On Inop—The HSD-440 Mark 2 Terminal is configured to log
on automatically but the terminal is in an inoperable state. Clear all
problems for the logon to continue.
• Logged-On Constrained—The HSD-440 Mark 2 Terminal is logged on
manually.
• Logged-On Auto—The HSD-440 Mark 2 Terminal is logged on
automatically.
• Logging-off—TheHSD-440 Mark 2 Terminal is in the process of logging
off.
• Logging-on—The HSD-440 Mark 2 Terminal is in the process of logging
on.
To view the log status:
1. On the main page of the MCDU, press the key next to SUBMENU.
The SATCOM SUBMENU page appears.
The logon state appears on the line below LOG-ON STATE.
You can view additional details about the logon, including the GES and satellite
name. To view additional logon details:
1. On the main page of the MCDU, press the key next to SUBMENU.
The SATCOM SUBMENU page appears.
2. On the SUBMENU page, press the key next to LOG-ON.
The SATCOM AERO LOG-ON screen appears as shown below. The logon
state appears on the line below LOG-ON STATE. You can also view the GES
name, satellite name, signal level, antenna type, azimuth and elevation, and
8-digit ICAO ID.
NOTE: If the HSD-440 Mark 2 Terminal is logged off, the LOG-OFF option
is not available. If the HSD-440 Mark 2 Terminal is logged on, the
AUTO LOG-ON option is not available.
(b) Initiating an Automatic Logon
When the HSD-440 Mark 2 Terminal logs on automatically, it selects an
appropriate GES and satellite based on its position.