User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 2-6
3 JUN 10
(b) Connecting to the Maintenance Port
To connect to the maintenance port:
• Connect a computer running a terminal emulation program to the HSD-440
Mark 2 Terminal maintenance port, and then power up the system. (Refer
to
"Test and Fault Isolation" on page 4-35 for detailed connection
information.)
(c) Changing LES Access Codes Using the Control Processor Software
To change all of the LES Access Codes simultaneously to the same LES Access
Code:
1. Connect to the HSD-440 Mark 2 Terminal maintenance port.
2. Type the password maint.
3. To navigate to Menu 3, press CTRL + N.
4. In Menu 3, press i.
5. Follow the application prompts, and enter the LES Access Code.
The Menu 3, option i configures the Primary and Secondary LES Access Codes
for all of the ORs to the same LES Access Code.
NOTE: In cases where the Service Provider requires different LES Access
Codes for different ORs, each LES Access Code must be programmed
individually using Menu 3, item P.
(d) Changing LES Access Codes on a Call-by-Call Basis
To change the LES Access Code on a call-by-call basis:
• Dial the 901 prefix before your dial sequence:
901 + LES CODE + International Code + Country Code + Area Code +
Telephone Number + POUND KEY
Example: 901 + 012 + 00 + 1+ 613+5551212 + #
NOTE: The call connects only if the service is authorized by the LES. To
obtain LES codes, call your Swift 64 service provider.
J. Removing the LED Label
A label covers the LES Access Codes LEDs. You can remove this label once you have
configured the LES Access Codes.
K. Activating Configurations
After you configure the HSD-440 Mark 2 Terminal parameters, you must rest the
HSD-440 Mark 2 Terminal using one of the following methods:
• In Menu 2, press z
• Cycle the power to the HSD-440 Mark 2 Terminal
When the reset or restart is completed, the configuration values and parameters are
activated.