User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 1-16
3 JUN 10
Figure 1-4 HSD-440 Mark 2 Terminal ISDN Connections
You can install RJ45 interface connectors in th
e cabin area to facilitate connection to the
ISDN interface. Refer to "Installation" on page 3-1 for a description of the RJ45 connector
and cable termination.
E. Ethernet Data Interfaces
HSD-440 Mark 2 Terminals provide two Ethernet data interfaces. Each Ethernet port
provides a 10 Mbps
access with a 10BASE-T physical interface. The HSD-440 Mark 2
Terminal data I/O controller takes the PPP data stream and directs it to the required port
on the channel card, depending on the type of service selected by the user. PPPoE is
required on the user equipment to allow the establishment of virtual connections to either
service. You can use the Ethernet ports for either Mobile ISDN or MPDS service when
operating in Swift 64 mode, or PS (background or streaming) or CS (Mobile ISDN) when
operating in SBB mode
The Ethernet interface also provides access to
equipment monitoring functions through
SNMP, and to the side AT handler for control of secondary contexts in SBB
F. POTS Tip/Ring Interfaces
The HSD-440 Mark 2 Terminal includes two POTS an
alog interfaces that connect to the
Swift 64/SBB channel card. The default setting for POTS port 1 is 64 kbps Speech, and
the default setting for POTS port 2 is 3.1 kbps Audio, which is appropriate for fax calls.