User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 6-29
3 JUN 10
To configure field loadable software:
1. In the list of ORT parameters, type the number next to the SW FIELD
LOADABLE parameter, and then press ENTER.
2. To enable the file transfers, type 1, or to disable the file transfers, type 0, and
then press ENTER.
The default is DISABLED.
(7) Configuring the Logon/Handover Policy
The logon/handover policy determines if the equipment automatically logs on, or
waits to log on, or changes satellite when the instruction is received from the pilot.
The policy options are automatic and manual. The default policy is automatic. The
logon/handover policy parameter is in the user partition of the ORT.
To configure the logon/handover policy:
1. In the list of ORT parameters, type the number next to the LOG-ON/HANDOVER
POLICY parameter, and then press ENTER.
2. To select automatic logon, type 1, or to select manual logon, type 0, and then
press ENTER.
The default is AUTOMATIC.
(8) Configuring Logon Interrogation
The response to logon interrogation enables the AES to be interrogated. The logon
interrogation parameter is in the user partition of the ORT.
To enable the logon interrogation:
1. In the list of ORT parameters, type the number next to the RESPONSE TO
LOG-ON INTERROGATION parameter, and then press ENTER.
2. To enable interrogation, type 1, or to disable interrogation, type 0, and then press
ENTER.
The default is DISABLED.
(9) Configuring High-rate R/T in Global Beam
The High-rate R/T in global beam parameter enables or disables high-rate in Global
Beam. The high-rate R/T is in the user partition of the ORT.
To enable or disable high-rate R/T:
1. In the list of ORT parameters, type the number next to the HIGH RATE R/T IN
GLOBAL BEAM parameter, and then press ENTER.
2. To enable high-rate in Global Beam, type 1, or to disable high-rate in Global
Beam, type 0, and then press ENTER.
The default is DISABLED.
(10)Masking Position in Logs
The HSD-440 terminal can record the position of the aircraft in the HSD-440 terminal
logs. You can enable and disable the recording of position information with the mask
position in logs parameter. This parameter is in the user partition of the ORT.