User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 6-25
3 JUN 10
To configure outgoing call pre-selection:
1. In the list of ORT parameters, type the number next to the COCKPIT OUTGOING
CALL PRE-SELECT parameter, and then press ENTER.
2. To enable pre-selection, type 1, or to disable pre-selection, type 0, and then press
ENTER.
The default is DISABLED.
(9) Configuring the Address Book Categories
The address book defines a table that can hold up to 400 telephone numbers in 4
categories of up to 100 entries. Each entry includes:
• A phone number (maximum of 18 digits).
• A name (maximum of 14 alphanumeric characters).
• A priority for the phone number. The priority can be EMG, OP-HI, OP-LO, and
NON-OP, which correspond to priority (Q) numbers 15, 12, 10, and 9.
• A parameter to indicate whether the entry can be edited via the MCDU.
• A parameter to indicate the phone book category to which the entry belongs.
You can define up to four phone book categories in the MCDU address book. The
category name can be up to ten characters in length. The category name parameters
are in the secure partition of the ORT.
NOTE: If the ORT entry is empty, CATEGORY #x appears, where x is the number
of the phone book category, between 1 and 4.
To configure the address book categories:
1. In the list of ORT parameters, type the number next to the PHONEBOOK CAT
NAME 1 parameter.
2. Type the category name and then press ENTER.
3. In the list of ORT parameters, type the number next to the PHONEBOOK CAT
NAME 2 parameter.
4. Type the category name and then press ENTER.
5. In the list of ORT parameters, type the number next to the PHONEBOOK CAT
NAME 3 parameter.
6. Type the category name and then press ENTER.
7. In the list of ORT parameters, type the number next to the PHONEBOOK CAT
NAME 4 parameter.
N. Configuring the CMU
(1) Configuring CMU Wiring
You can configure if either of the two available CMUs is wired. The CMU #x WIRED
parameter is in the secure partition of the ORT.