User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 6-20
3 JUN 10
is not specified, is not assisted. If the timing mode is not assisted, the HSD-440
Mark 2 Terminal is set as Aeronautical Class without GPS BGAN terminal.
(7) Configuring the Priority Service for Channel Card One
Channel card one can access SBB and Swift 64 services. You can assign the priority
service with the following options:
• SWIFT64 ONLY
• SWIFTBROADBAND CLASS 6 REVERTING TO SWIFT64—default
• SWIFTBROADBAND CLASS 6 ONLY
• SWIFT64 REVERTING TO SWIFTBROADBAND CLASS 6
The priority service is in the secure ORT.
To configure the priority service for channel card one:
1. In the list of ORT parameters, type the number next to the CARD #1 SBB/S64
PRIORITY parameter, and then press ENTER.
2. At the prompt, type 0, 1, 2, or 3 and then press ENTER, where:
• 0—SWIFT64 only on CC1
• 1—SWIFTBROADBAND CLASS 6 REVERTING TO SWIFT64
• 2—SWIFTBROADBAND CLASS 6 ONLY
• 3—SWIFT64 REVERTING TO SWIFTBROADBAND CLASS 6
The default priority service is SWIFTBROADBAND CLASS 6 REVERTING TO
SWIFT64.
(8) Configuring the Service Type Priority
The service type priority parameter defines which service gets second priority for
power when the requirements for priority three and above Aero H calls are satisfied.
The service type priority parameter is in the secure ORT.
To configure the service type priority:
1. In the list of ORT parameters, type the number next to the SERVICE TYPE
PRIORITY parameter, and then press ENTER.
2. To configure PUBLIC CORRESPONDENCE, type 0, or to configure SBB/S64,
type 1, and then press ENTER.
The default is PUBLIC CORRESPONDENCE.
L. Configuring Antenna ORT Parameters
(1) Configuring the Antenna Type
The antenna type parameter defines the type of antenna installed on the aircraft. The
available options are:
• ARINC 781 HGA
• ARINC 781 IGA
• ARINC 741 HGA, Top Mount—default