User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 6-18
3 JUN 10
(4) Configuring the Frequency Table
The Frequency Table defines
the Global Band (SBB) and PSID (Areo H/H+)
frequencies for up to eight satellites. You can configure two or more frequency pairs
and NCS (S64) for each service type. The Frequency Table is in the secure ORT.
The default settings are:
Entry # Region Service Type Frequencies Frequencies
1 0 AERO PSID FREQS: $3702, $36B8 NCS FREQS: $2AAC,$30E0
2 1 AERO PSID0 FREQS: $36FE, $36B6 NCS FREQS: $2AB0,$30E4
3 2 AERO PSID FREQS: $36B4, $3700
4 3 AERO PSID FREQS: $36B2, $36FC
5 4 AERO PSID FREQS: $38F7, $38F7
6 5 Global Beam FREQS: $2AF2, $302A AERO PSID FREQS: $36DA, $36DA
7 6 Global Beam FREQS: $2BA0, $309E AERO PSID FREQS: $36DE, $36DE
8 7 Global Beam FREQS:$2A4C, $3004 AERO PSID FREQS: $36DC,$36DC
To configure the Frequency Table:
1. In the list of ORT parameters, type the number next to the FREQUENCY TABLE
p
arameter, and then press ENTER.
2. Type the EN
TRY number you want to edit and then press ENTER.
3. At the S
BB GLOBAL BEAM FREQS prompt, type the frequency pair and then
press ENTER.
4. At the AERO PSID
FREQS prompt, type the frequency pair and then press
ENTER.
5. At the SW
IFT64 NCS FREQS prompt, type the frequency pair and then press
ENTER.
6. At the SA
VE ENTRY prompt, to save the changes, type Y, or to cancel, type N.
NOTE: You must enter a minimum of two frequency pairs per service type for each
satellite up to a maximum of eight satellites. Frequency pairs are
hexadecimal, with values separated by a comma, for example,
$3702, $36B8.