User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 6-15
3 JUN 10
To configure GNSS equipment:
1. In the list of ORT parameters, type the number next to the A/C GNSS
EQUIPMENT parameter, and then press ENTER.
2. At the prompt, type 0, 1, or 2, and then press ENTER, where:
• 0—disables GPS protection on an aircraft that does not have GPS
augmented by GLONASS navigation equipment installed
• 1—enables GPS protection on an aircraft that has GPS navigation
equipment installed
• 2—enables GPS protection on an aircraft that has GPS augmented by
GLONASS navigation equipment installed
The default is GPS.
(5) Configuring the ICAO Code Source
You can provide the ICAO code by strapping or from the ARINC 429 source. You
can use the ARINC 429 source only if the Secondary IRS Type parameter is set to
AES ID.
The ICAO code source parameter is in the secure ORT.
To configure the ICAO code source:
1. In the list of ORT parameters, type the number next to the ICAO CODE SOURCE
parameter, and then press ENTER.
2. To configure A429 SOURCE as the source, type 1, or to configure STRAP inertial
as the source, type 0, and then press ENTER.
The default is STRAP.
K. Configuring Satellite Service ORT Parameters
(1) Configuring the Forward ID
You can configure the six-digit hexadecimal Forward ID required for Swift 64 services.
The Forward ID is in the secure ORT.
To configure the Forward ID:
1. In the list of ORT parameters, type the number next to the FORWARD ID
parameter, and then press ENTER.
2. To define the forward ID, type the forward ID, then press ENTER.
The default forward ID is 000000—this forward ID does not allow access to the
satellite network.
NOTE: Power cycle the HSD-440 Mark 2 Terminal to activate the new Forward
ID.