User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 6-10
3 JUN 10
(2) Configuring Ethernet Duplex Mode
You can define the duplex mode for the Ethernet ports. The available options are:
• ETH1=HALF Duplex, ETH2=HALF Duplex
• ETH1=FULL Duplex, ETH2=HALF Duplex
• ETH1=HALF Duplex, ETH2=FULL Duplex
• ETH1=FULL Duplex, ETH2=FULL Duplex
The parameter for the Ethernet duplex mode is in the secure ORT.
To configure Ethernet duplex mode:
1. In the list of ORT parameters, type the number next to the ETHERNET DUPLEX
MODE parameter, and then press ENTER.
2. At the prompt, type 0, 1, 2, or 3, and then press ENTER, where:
• 0—half duplex for both ports
• 1—full duplex mode for Ethernet 1 only
• 2—full duplex mode for Ethernet 2 only
• 3—full duplex mode for both Ethernet 1 and Ethernet 2
The default is 0.
A message similar to the following appears:
PROCEEDING TO STORE DATA
(3) Configuring the Ethernet Port Address
You can configure the base IP address for each of the two Ethernet ports. The
parameters that define the Ethernet port addresses are in the secure ORT.
To configure the Ethernet port addresses:
1. In the list of ORT parameters, type the number next to the ETHERNET 1
ADDRESS parameter, and then press ENTER.
2. Type an IP address using decimals ranging from 0-255, in the format
xxx.xxx.xxx.xxx, and then press ENTER.
The default address for Ethernet 1 is 192.168.0.1. The default address for
Ethernet 2 is 0.0.0.0.
(4) Configuring the Ethernet Mask
You can configure the network mask for each of the two Ethernet ports. The
parameters that define the Ethernet port network masks are in the secure ORT.
To configure the Ethernet port masks:
1. In the list of ORT parameters, type the number next to the ETHERNET 1 MASK
parameter.
2. Type an IP address using decimals ranging from 0-255, in the format
xxx.xxx.xxx.xxx, and then press ENTER.
The default subnet mask for both Ethernet ports is 255.255.255.0.