User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 6-1
3 JUN 10
CONFIGURING THE OWNERS REQUIREMENTS TABLE
(ORT)
There are two methods of configuring ORT parameters:
• Configuring ORT Parameters Using the MPU
• Configuring ORT Parameters Using the EMS ORT Application
When your computer is connected to the HSD-440 Mark 2 Terminal through the serial maintenance
connection, you can set ORT parameters one at a time.
Using the EMS ORT Application, you can edit various ORT parameters in one session, save and
export an ORT file, and then load the file into the HSD-440 Mark 2 Terminal.
1. Configuring ORT Parameters Using the MPU
For information on creating ORTs using the MPU , see "Creating ORTs with the Maintenance Port
Utility (MPU)" on page 2-4.
This section lists the parameters you can configure in both the secure partition and the user partition
of the ORT. See the individual procedure for more information.
You can use the MPU to configure the secure parameters described in Table 6-1:
Table 6-1 Configuring Secure ORT Parameters
Category Section
ORT Part Number Configuring the ORT Part Number (secure)
Cockpit Communications Configuring the Call Signaling Mode
Configuring Outgoing Call Signaling
Configuring Ground Public Routing
4-wire Configuring 4-wire Wiring
Configuring Ground-to-Cockpit Call Routing
Configuring 4-wire Parameters
POTS Configuring POTS Parameters
CEPT-E1 Configuring CEPT-E1 Interface
Configuring the CEPT-E1 Interface Type
High Speed Data Services Configuring the Default PPPoE Service
Configuring SCPC High Speed Service
Configuring MPDS High Speed Service
Configuring SBB High Speed Service
Ethernet Configuring Ethernet Wiring
Configuring Ethernet Duplex Mode
Configuring the Ethernet Port Address
Configuring the Ethernet Mask