User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 4-87
3 JUN 10
To save a diagnostics reports file:
1. Open a log file on the maintenance port, terminal program. (If you are using
HyperTerminal, use the "Transfer, capture text" function.)
2. Power the system on or if applicable reset the system.
3. Enter maintenance mode on the maintenance port using maint as the password.
4. To activate reports 21 and 23 and toggle off all other reports, press EQUAL SIGN.
5. To save these reports as default, press S. This enables the user to view these
reports on subsequent HSD-440 Mark 2 Terminal power-ups or Reset entries.
6. Reset the system by cycling the power to the terminal; pressing the reset button
on the HSD-440 Mark 2 Terminal front panel; or, in Menu 2, pressing Z.
NOTE: The HSD-440 Mark 2 Terminal must be logged on to the Aero H+
service.
7. Log on to the maintenance port using the password: maint
The system restarts and ocean registration takes place (approximately two
minutes).
8. To display Menu 2, press CTRL+N.
9. To display the software versions of the system, press V.
10.Make a call from the system or execute the procedure or sequence that causes
the call failure. Make a note of the call progress. For example: Did you get a dial
tone? Was the call successful?
11. If applicable, attempt calls from the remaining three channels.
12.To display the current reports profile of the system (as noted in step 4), press
EQUAL SIGN.
13.To save an alternate reports configuration, activate the required items, and then,
to save to EEPROM, press S in the reports menu.
14.To display the ORT List, press CTRL+N until Menu 3 appears, and then press
O. (The ORT list displays one terminal screen of information at a time. To display
the next screen, press O.)
15. To list the complete event log, in Menu 3:
• press S (list event log)
• press 0 (list complete log)
• press PERIOD (list all remaining entries)
16.To list the complete call log, in Menu 3:
• press F (list call log)
• press F again (list complete log)
• press PERIOD (list all remaining entries)
• for extended information, press X
17.Close the log file on the terminal program.