User's Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion® HSD-440 Mark 2 Terminal
23-15-30 4-59
3 JUN 10
These reports are commonly used for testing and troubleshooting the system
an
d are only available to Level 2, maint access users.
NOTE: Depending on the version of software installed and the user's
selection of reports, the MPU reports displayed may differ from those
shown in the example in Figure 4-17.
port status $608033 SDI: ACU SSM: NORMAL gain=12.0
OMNIDIRECTIONAL MODE open loop tracking port/top active HGA LNA=on
Figure 4-17 Example of Report 20
Table 4-18 shows descriptions of the items in reports 8 and 20.
Table 4-18 Reports 8 and 20 Item Descriptions
Report 8 and 20 Starboard and Port Antenna Status
(Hex code) - Raw hex code of the 32-bit ARINC word—decoded message follows code
(SDI) - Antenna being used (for mechanically steered, only Port data is valid)
(SSM) - Antenna serviceability
(Gain) - Reported antenna gain (may vary with increased blockage or keyhole
po
inting)
(Mode) - Reports tracking status, antenna selection, and high gain mode
(LNA) - Power-on status
4. Report 21
Report 21 displays the call code info
rmation for the HSD-440 Mark 2
Terminal.
Figure 4-18 shows an example of report 21. Table 4-19 describes the items
in report 21.
23:48:36 #1 123ABC E4 start 400110 14.00 dBW CT SP ocean region registration
41.5 C 51 dB Hz
23:48:39 #1 123ABC E4 stop 8301 ACSE successful ORR 41.5 C 51 dB Hz
23:49:20 #2 456DEF E5 start 400110 14.00 dBW CT SP ocean region registration
41
.5 C 52 dB Hz
23:49:24 #2 456DEF E5 stop 8306 ACSE failed retry ORR 41.5 C 51 dB Hz
23:49:27 #2 456DEF E5 start 400110 14.00 dBW CT SP ocean region registration
41
.5 C 52 dB Hz
23:49:32 #2 456DEF E5 stop 8306 ACSE failed retry ORR 41.5 C 51 dB Hz
23:49:36 #2 456DEF E5 start 400110 14.00 dBW CT SP ocean region registration
41
.5 C 51 dB Hz
23:49:40 #2 456DEF E5 stop 8301 ACSE successful ORR 41.5 C 52 dB Hz
Figure 4-18 Example Report 21